top of page

F1 2024

Setup Guide



Supported versions of F1 2024

Windows PC



Supported Telemetry Apps


Jump to instructions for RS Dash ASR

Jump to troubleshooting



These instructions for specifically for the "RS Dash ASR" app. There are instructions for the regular "RS Dash" app further below"

In the RS Dash ASR app
  • Start RS Dash ASR and login to / register your account.

  • Select [Launch] button from the navigation bar along the bottom of the screen.

  • Select [Formula 1 2024] as the Sim Racing Game

  • Select a Dashboard Layout you want to display

  • Select a Recording Option, or disable recording. Note: Recording should only ever be enabled on a single device at a time.

  • Click the [LAUNCH] button

  • Each device will now indicate it is waiting for telemetry data. The IP address of the device will be displayed. You will need this information when setting up the telemetry in F1 2024.

RS Dash ASR Setup
In the F1 24 game
  • Select [Game Options]

  • Select [Settings]

  • Select [Telemetry Settings]

  • Set "UDP Telemetry" to "On"

  • Set "UDP Broadcast Mode" to "Off" if you are only running RS Dash ASR on a single device, otherwise set this to "On".

  • Set "UDP IP Address" to the IP address of your mobile device as shown in RS Dash ASR earlier. If you are running RS Dash ASR on multiple devices, enter the IP from any one of the devices.

  • Set the "UDP Port" to "20777"

  • Set the "UDP Send Rate" to "30Hz" (note: higher values may cause lag)

  • Set the "UDP Format" to "2024"


Start a session so you are on track or in the garage (Note: the game only sends telemetry while in an active session)

The app should now show the dashboards once you are in an active session in the game.


  • Note: Please be aware that the game will only start sending telemetry data to the app once you start driving, so prior to that point the app will still indicate that it is waiting for the game to start.

  • Try to disable Broadcast Mode and specify the direct IP address of one of your mobile device(s). Only applicable if broadcast mode was being used.

  • If you are trying to map buttons from your racing wheel to functions in RS Dash, make sure you are in the game (pit garage or on track) and not paused. For example just start a Time Trial session, any car and track. Once it loads you into the pit garage before you choose to start your time trial lap, you will be able to assign buttons here. 

More Troubleshooting Options

Networking/Connectivity Troubleshooting Tips

General Troubleshooting Tips

bottom of page